Professional Concrete Floor Cleaning

Poured concrete is one of the most durable and widely used commercial and industrial flooring surfaces. This floor surface requires special attention when it comes to cleaning and care because it not only has to withstand a considerable amount of strain, but it also needs to meet OSHA slip-resistance standards at the same time. For daily maintenance, interim, and deep cleaning, it's therefore essential to select the right equipment.

A gray concrete floor

Daily Maintenance Cleaning: Removing Light Soil

Maintenance cleaning is carried out using a single-pass method. To remove light soiling, the floor scrubber is fitted with red scrubbing brushes or pads. The floor scrubber works with a reduced contact pressure and lower cylindrical brush speed. A suitable cleaning agent would be a daily and interim cleaner for industrial use diluted to between 0.5 and 3 percent, depending on the amount and type of dirt. We also recommend equipping the machine with the auto-dosing function. Mopping or rinsing is not required; the floor can be walked on again immediately.

If the cleaning job does not require wet cleaning, a walk-behind or ride-on sweeper can also be used for maintenance cleaning.

A worker performs maintenance cleaning with a ride-on floor scrubber.
Deep cleaning step 1

Step 1: Use a floor scrubber to cover the area that needs cleaning with a cleaning agent and then scrub it two or three times until all the dirt has come loose.

Deep cleaning step 2

Step 2: Remove the dirty water using the squeegee and the vacuum function on the machine. Then cover the entire area with clean water again and finish with a single-pass clean-water rinse: apply water, scrub, and recover.

Illustration of a floor scrubber with dual cylindrical brushes
Illustration of a cylindrical scrub deck with dual brushes